I haven't tried to dig into the PPD, as PostScript isn't one of my areas of strength, but I'm reasonably sure it's correct. So, in brief, exported PDF prints properly (and this is a workaround), but it's a pain that Id has this issue. Printer prompts for correct media size, content prints as expected, again, to 5mm from media edge.
Printed test document from Acrobat XI, using "Actual Size", "Choose paper source by PDF page size", and "Use custom paper size when needed".Content in test file prints as expected, to 5mm from media edge. Printed using Preview, same OS X page setup configuration. The result of the test is that the content is cut off at 10-11mm from the edge instead. The specs for (and my experience with) the printer are that the printable area is 5mm from the edge of the paper. Created a test document, with same settings, and a scale extending outside of the printable area.Recreated document, re-entering sizes and verifying setup.Print dialog: "Setup", paper size Width and Height, correct orientation correct, offset and gap 0p0, scale 100%.Print dialog: "Page Setup." format for (custom media size defined for OS X), also verified to be correct for media.Document Setup: Custom Page Size, verify correct for media.The printer control panel prompts for and accepts the media size correctly (I believe these printers have checks to ensure media fed matches the printable area the Phaser engine doesn't like printing "off the paper").Īgain, the same document has been used for many years, so I've tried the following steps to isolate and remediate the problem: What's happening is that the printable area on the stock isn't being fully used - the top and bottom of the media aren't being printed - thus the top and bottom of the content is being cut off, in a way that wasn't an issue previously. The project is a one page table printed on this particular card stock. The problem may be in the way Id CC interacts with the MacOS X printing system. I've used the same Id document and workflows since, probably, Id 2 or 3, updating each time to the latest versions.
I have a project that I periodically modify and re-print on custom size media (3.25" x 7.36").
Perhaps this is a bug, but I'd rather ensure that there isn't something here that I haven't understood. I've got a strange problem that I hope someone can provide some insight to.
0 kommentar(er)
